Geothermal Logging Applications

Temperature and differential temperature (up to 400°C)

Used to estimate heat flow, find feed zones and to find out the fluid flow and the formation temperature in the geothermal system.

Pressure logs (400°C)

To estimate flow irrigate of the bedrock which is governed by the permeability of the rock, the viscosity of the liquid and a distribution of pressure. Production leads to a decline in pressure in the geothermal system.

Caliper logs

To measure the dimension of the well and show cavities where the well is drilled through soft formation, scaling in the well, etc. The tools have either 3 or 4 arms (two pairs). A caliper log is measured continuously from bottom to top and the device sends the data to the surface in real time.

Resistivity logs 16”, 64” & SP

Measures the electric resistivity of the rock around wells. The resistivity depends on the porosity of the rock along with salinity and the temperature of the liquid in the porous medium.

Neutron logs (n-n)

A neutron source (Am-Be/Ra-Be), placed in the device, sends out high energy neutrons. The n-n logs are useful for estimation of the porosity.

Natural gamma ray logs

A natural gamma radiation of rock comes from radioactive isotopes, especially K, U’s and Th. A correlation interposes silica content in Icelandic rock and its natural gamma radiation.

Televiewer

Emits acoustic pulses and detects their reflection from the surroundings, to detect shape, formation, fractures, casing damage, and other irregularities in the well and its surroundings. 

Full-Waveform - Compensated Sonic Probe

To measure formation acoustic-velocity.

Fluid sampling in wells

To find the chemical composition of the fluid.

Fluid Flow

The continuous flow-meter spinner is logged to obtain an overall picture of inflow zones within the borehole.

Cement bound logs (CBL)

To estimate the quality of the cementing of the casings in the well. If casings are badly bounded to the formation it can collapse and cause serious damage to the well. The CBL-device emits an acoustic signal which propagates from the emitter in the probe along the casing to the two receivers higher up in the probe.

Collar Casing Locator (CCL)

Is used to detect variation in the amout of iron in the vicinity of the CCL tool. The recording of the CCL signal is used to locate casing joints and casing damages.

Downhole VideoCamera (80°C)

Motion pictures can be taken down to 600 m depth if the temperature is not higher than 80°C. The pictures can be shot either sideways or directly downwards. This equipment is used for studies of fractures, scaleing, and casing damage.

Gyroscopic logging

Used in directional drilling to steer the drill bit along the planned track of the well. A real-time information about the inclination, the azimuth (true-north) and gyrotoolface of the well is recorded. The information is used to calculate the exact coordinates of the track. Two types of instruments are used, one type used for kick-off measures individual points, and the other type records continously.

Contact:
Hörður Halldórsson
Electronic Engineer

+354 528 1570
+354 696 1515
hoh@isor.is